Body Components

The Tie Down Engineering dock system inside roller ramp bracket is used to create custom dock setups. These components are commercial-grade 1/4 inch thick galvanized steel and includes both the left and right ramp brackets.

Guides adapt to most tube and channel trailer frames. Galvanized for long-lasting protection and include heavy-duty steel component parts. Bright orange end caps on these PVC guides provide a visible target when loading your boat. Boat guides are 48 inches high with up to 16 inches of side adjustment. All mounting hardware is included.

Heavy-duty, trailer-mounted guideposts are designed to assist in loading larger pontoon boats in rough water or high winds. Posts are hot dip galvanized 2.5 inch square steel, covered with molded PVC material. Designed to mount on the trailer between the pontoons. Mounts to trailer cross members 2 inches wide by 2-3 inches high. All mounting hardware is included.

Zinc plated roller shaft with pal nuts for mounting 4 inch bow, keel, or wobble rollers with 1/2 inch diameter hole.

These 13-inch rubber rollers mount on top or beneath the frame for precise placement. The galvanized guide mount tubes can be adjusted up to 13 inches in width on each side. Brackets and hardware fit trailer frame rails up to 2 inches wide and 2 inch, 3 inch and 4 inch in height. Sold in pairs with all mounting hardware included.

Non-marring PVC post helps guide the boat safely onto the trailer and gives a visual aid when backing an empty trailer. The 13 degree slant post provides a wider target when loading the boat. Metal bracing runs 15 inches into the pipe, adding strength and impact resistance. All mounting hardware included.

Tie Down's roller guides angles adjust to fit the angle of your boats' hull, helping safely center the boat for trailering. This roller guide provides up to 16 inches of adjustment (8 inches on each side) to fit the specific angle of your hull. The guide includes hot dip galvanized steel components with a one-piece adjustable clamp and U-bolt. Designed to fit all channel and tube frames up to 5 inches.