Tie Down Engineering

Non-marring PVC post helps guide the boat safely onto the trailer and gives a visual aid when backing an empty trailer. The 13-degree slant post provides a wider target when loading the boat. Metal bracing runs 15 inches into the pipe, adding strength and impact resistance. All mounting hardware included.

Designed to support 2 x 4 wood bunks, 2 x 6 wood bunks, or Tie-Down Engineering's roller bunks on boat trailers. Slotted for vertical adjustment and feature non-slip dimples to avoid movement and increase load capacity. Hot dip galvanized for lasting protection.

Tie Down Engineering 25-foot winch strap. Winch straps are 2 inch wide and have an overall tensile strength of 5,000 lbs. Each strap comes with a heavy-duty forged latch hook.

Self-centering bunk glide on's make launching and loading effortless without damaging the hull of painted, fiberglass, or aluminum boats.

Tie Down Engineering 3-inch x 16-inch bunk slicks screw directly onto carpeted bunk boards to allow the boat to gently slide on or off the trailer. Ten pieces per pack.

Tie Down's roller guides angles adjust to fit the angle of your boats' hull, helping safely center the boat for trailering. This roller guide provides up to 16 inches of adjustment (8 inches on each side) to fit the specific angle of your hull. The guide includes hot dip galvanized steel components with a one-piece adjustable clamp and U-bolt. Designed to fit all channel and tube frames up to 5 inches.

Tie Down marine bunk board guide-ons are black, 2x4 carpeted bunk boards that are sold in pairs that will include all of the galvanized mounting hardware. The posts can be attached 5-11 inches on the side of the frame. If these posts are put above the frame, the bunk placement is 19 inches high. The U-bolts and nuts are plated in zinc. The kit frames 2-3 inches wide and 4 inches high.

Self-centering bunk glide on's make launching and loading effortless without damaging the hull of painted, fiberglass, or aluminum boats.

Tie Down Engineering 1-3/4 inch x 17 inch bunk slicks screw directly onto carpeted bunk boards to allow a boat to gently slide on or off the trailer.

Pontoon trailer guides aid in loading the boat onto the trailer by raising up 12 inches when the trailer is submerged. Bright orange end caps on these PVC guides give you a brighter target when loading. These guides are designed to be mounted between the pontoons. Made of 1.5 inch square, 16 gauge steel galvanized tubing and covered by 2 inch x 20 inch PVC pipe. Mounts to trailer cross members 2 inch wide by 2, 3, or 4 inches high. All mounting hardware is included.