Trailer Guides & Bunks

Designed to absorb the impact of the hull and protect the boat's finish when loading for trailering. Heavy-duty galvanized steel frame provides full hull support. Roller bunks can be adjusted vertically with optional bolster support swivel brackets. Bunk kits do not include mounting hardware.

Pontoon trailer guides aid in loading the boat onto the trailer by raising up 12 inches when the trailer is submerged. Bright orange end caps on these PVC guides give you a brighter target when loading. These guides are designed to be mounted between the pontoons. Made of 1.5 inch square, 16 gauge steel galvanized tubing and covered by 2 inch x 20 inch PVC pipe. Mounts to trailer cross members 2 inch wide by 2, 3, or 4 inches high. All mounting hardware is included.

Designed to simplify loading Jon boats, bass boats, and personal watercraft onto boat trailers. The guide posts are made of 1.5 inch square, 16 gauge galvanized steel. The covers are made from high-impact non-marking molded PVC. Mounts to trailer cross members 2 inches wide and 2 to 4 inches high. All mounting hardware is included.

Designed to support 2 x 4 wood bunks, 2 x 6 wood bunks, or Tie-Down Engineering's roller bunks on boat trailers. Slotted for vertical adjustment and feature non-slip dimples to avoid movement and increase load capacity. Hot dip galvanized for lasting protection.

Designed to supports bolster or bunk boards on boat trailers. 11 gauge steel brackets mount 2 inch bunks on edge. Slotted for vertical adjustment to standard or deep-V hulls. Hot dip galvanized for extra protection.

The Tie Down Marine Bunk Board Guide-Ons are black, 2x4 carpeted bunk boards that are sold in pairs that will include all of the galvanized mounting hardware. The posts can be attached 5-11 inch on the side of the frame. If these posts are put above the frame, the bunk placement is 19 inches high. The U-bolts and nuts are plated in zinc. The kit frames 2-3 inches wide and 4 inches high.

Tie Down's roller guides angles adjust to fit the angle of your boats' hull, helping safely center the boat for trailering. This roller guide provides up to 16 inches of adjustment (8 inches on each side) to fit the specific angle of your hull. The guide includes hot dip galvanized steel components with a one-piece adjustable clamp and U-bolt. Designed to fit all channel and tube frames up to 5 inches.

Guides adapt to most tube and channel trailer frames. Galvanized for long-lasting protection and include heavy-duty steel component parts. Bright orange end caps on these PVC guides provide a visible target when loading your boat. Boat guides are 48 inches high with up to 16 inches of side adjustment. All mounting hardware is included.

Bright orange end caps on these PVC guides provide a bright, visible target when loading your pontoon boat. The guide posts are designed to be mounted between the pontoons. Made of 1-1/2 inch square, 16-gauge steel tubing and covered by 2 inch x 20 inch PVC pipe. Hot-dip galvanized guide posts extend fully into the PVC tube for additional strength. Mounts to trailer cross members up to 2 inches wide by 2 inches high. All mounting hardware included.

Non-marring PVC post helps guide the boat safely onto the trailer and gives a visual aid when backing an empty trailer. The 13-degree slant post provides a wider target when loading the boat. Metal bracing runs 15 inches into the pipe, adding strength and impact resistance. All mounting hardware included.

Tie Down Engineering 1-3/4 inch x 17 inch bunk slicks screw directly onto carpeted bunk boards to allow a boat to gently slide on or off the trailer.